Goodro Kitchen and Bath Co.,Ltd
Tel:86-18106909390
E-mail:info@goodrofaucets.com
Products
[[TD-Hot Products]]
Exhibition
Home > Exhibition > Content

Installation methods of various faucets

Goodro Kitchen and Bath Co.,Ltd | Updated: May 17, 2017

Before installation, the first to prepare the installation tools, installation before checking the complete part of the accessory, common leading parts are: hoses, rubber washers, shower, water, guaizi, decorative caps and so on. Next, introduce a variety of faucet installation methods.


First, the installation of single-hole kitchen faucet


Requires a solid, because the kitchen faucet high frequency, coupled with being moved to move, easy to loose, so the lock nut must be tightened. At present, the market appeared some of the leading screw for the nut to increase the fixed, this solid effect is very good, if you can solve the problem of water to pull, the future will be a popular trend.

p201612151329090595818.png

Second, the installation of single-hole basin faucet


When you buy a single handle basin faucet should pay attention to the diameter of the outlet, and now most of the market belongs to the hard tube water, so you should pay attention to set the height of the sink, from the basin down 35 workers is the most appropriate. Installation, be sure to choose a special angle valve, and the angle valve and the wall must be hot and cold water pipe fixed. When you find a distance between the angle valve and the faucet on the faucet, go to buy a dedicated extension tube to connect. Remember, do not use other water pipes to connect, because if the water pressure, it is easy to fall off, leaking, causing you to lose. If the inlet pipe is too long to exceed the outlet pipe, according to your needs cut off the part of the angle is not appropriate, then according to the need to moderate bending to the location you need. Remember: do not bend hard to 90 degrees or greater than 90 degrees. When installing the basin to the water, please do not forget to buy a small interface (leading short). Do not forget to rinse the pipes buried in the wall before you install.

p201704202052516860689.jpg

Three, shower, bath faucet (wall) installation


When you buy a shower, bath, wall faucet, you can choose the appropriate height to bury the water pipe. Hot and cold water pipe spacing must reach 15 cm. Before you install, do not forget to rinse the water pipe, so as not to have excellent water quality, damage to the faucet. Concealed shower, bathtub faucet: the purchase of darkener faucet, the general spool of the faucet embedded in the wall. Be sure to pay attention to the thickness of the bathroom wall before embedding. If the wall is too thin, the spool will not be embedded. When the pre-embedded plastic cover of the spool should not be removed easily, so as not to damage the spool when cement and other chores are embedded. Also in the embedded spool should also pay attention to the upper and lower spool, left and right direction, so as to avoid spool error. Wall faucet embedded in the water pipe when the size of the deviation, can be used to adjust the kidnapping school.


Fourth, the installation of thermostatic faucet


Before installing the thermostatic faucet, please check the water pipe is not left hot right cold, remember not to catch hot and cold water pipes, so that the faucet can not work properly. Gas, solar water heaters can not use the thermostat, because the water pressure is too low. Do not forget to install hot and cold water filter.




Goodro Kitchen and Bath Co.,Ltd