Goodro Kitchen and Bath Co.,Ltd
Tel:86-18106909390
E-mail:info@goodrofaucets.com
Products
[[TD-Hot Products]]
Exhibition
Home > Exhibition > Content

How to replace kitchen sink mixer taps

Goodro Kitchen and Bath Co.,Ltd | Updated: Jun 16, 2017

1.Leaving the location, each family selected flume styles are different, so the table should be left out of the sink and the volume of the sink should be in line with the table, in order to inform the surface supplier sink the approximate size, in order to avoid the problem of rework.

2. Before installing the sink, the faucet and inlet pipe should be installed. Installation of the faucet, not only requires a strong installation, and the junction can not appear seepage.

3.Will sink some function accessories are installed, you can put the sink to the table in the corresponding position, ready to start the next step of the installation program.

4. Install faucet inlet pipe. will be installed in thefaucet in advance connected to the inlet of the water switch, installation should pay attention to the cohesion of the firm, but also pay attention to a detail, that is, the location of hot and cold water pipe, do not make a mistake.

5.Overflow hole is to avoid the water tank to overflow the protection of the hole, so in the installation of water pipe overflow hole, to pay attention to the sealing with the groove body, to ensure that the overflow hole of the water pipe itself does not leak.

p201612151325056487817.jpg

6.The filter basket under the sewer pipe in the installation, the main attention to the connection between the water pipe and groove, not only to be firm, but also to seal.

7.Usually people will buy two filter basket sinks, but two of the distance between the water pipe, workers in the installation, will be based on the actual situation of the drainage pipe to be cut, at this time to pay attention to each interface between the seal.

8.The sink into the table, the need to install in the trough and the table supporting the hanging piece, the tank will be installed firmly, to avoid small voids caused by the groove sway

9.The drainage test, after the basic installation, will be installed on the filter basket, start the next experiment. When doing the drainage test, the sink should be filled with water and the drainage of two filter baskets and overflow holes are tested. Drainage, if found where there is water seepage phenomenon, should be immediately rework, to ensure that the future use is not hindered.

Sealing edge around the groove, after the drainage test, to ensure that there is no problem in the case, the sink can be closed. In the use of silicone sealing edge, to ensure that the sink and Mesa connection gap evenly, can not have water seepage phenomenon.


Goodro Kitchen and Bath Co.,Ltd