Goodro Kitchen and Bath Co.,Ltd
Tel:86-18106909390
E-mail:info@goodrofaucets.com
Products
[[TD-Hot Products]]
Exhibition
Home > Exhibition > Content

How to replace bathroom sink faucets

Edit: Goodro Kitchen and Bath Co.,Ltd    Date: Jun 12, 2017

1. Preparation of work

Stay out of the location, each family selected flume styles are different, so the table should be left out of the tank and the volume of the sink should be in line with the table, in order to inform the surface supplier sink the approximate size, so as to avoid the problems of rework.

2. Faucet installation

The faucet and inlet pipe should be installed before installing the sink. Installation of sink faucet, not only requires a strong installation, and the connection can not appear water seepage phenomenon.

3. Place the sink

After installing some of the function parts of the sink, you can place the sink in the appropriate position on the countertop and prepare to start the next installation program.

4, Start to install sink faucet

The inlet pipe of the faucet is installed. will be installed in the faucet in advance connected to the inlet of the water switch, installation should pay attention to the cohesion of the firm, but also pay attention to a detail, that is, the location of hot and cold water pipe, do not make a mistake.

5. Installing the water pipe with overflow hole

Overflow hole is to avoid the water tank to overflow the protection of the hole, so in the installation of water pipe overflow hole, to pay attention to the sealing with the groove body, to ensure that the overflow hole of the water pipe itself does not leak.

6, Install the filter basket under the water pipe

In the installation of the sewer pipe under the filter basket, the main attention is attached to the connection between the water pipe and the groove body, not only to be firm, but also to be sealed.

7. Install the whole drainage pipe

Usually people will buy two filter basket sinks, but two of the distance between the water pipe is near, workers in the installation, will be based on the actual situation of the drainage pipe to be cut, at this time to pay attention to each interface between the seal.

8. Install the hanging piece to strengthen the trough body

After the sink into the table, the need to install in the trough and the table supporting the hanging piece, the sink will be installed firmly, to avoid a small gap caused by the groove sway.

9. Installation End

To carry out the drainage test, after the basic installation, will be installed on the filter basket, start the next experiment. When doing the drainage test, the sink should be filled with water and the drainage of two filter baskets and overflow holes are tested. Drainage, if found where there is water seepage phenomenon, should be immediately rework, to ensure that the future use is not hindered.

Sealing edge around the groove, after the drainage test, to ensure that there is no problem in the case, the sink can be closed. In the use of silicone sealing edge, to ensure that the sink and Mesa connection gap evenly, can not have water seepage phenomenon.


Goodro Kitchen and Bath Co.,Ltd