Goodro Kitchen and Bath Co.,Ltd
Tel:86-18106909390
E-mail:info@goodrofaucets.com
Products
[[TD-Hot Products]]
Exhibition
Home > Exhibition > Content

How to install 8 inch bathroom faucet

Goodro Kitchen and Bath Co.,Ltd | Updated: Jun 12, 2017

Bathroom Faucet Installation Method

1.Take out the faucet, check all the accessories are complete, before installation must clear the installation hole around and water supply pipeline of dirt, to ensure that the tap into the pipe no impurities. In order to protect the faucet surface not to be scratched, it is recommended to wear gloves for installation.

2. Remove the faucet rubber washer, the washer is used to relieve the pressure of contact between the faucet metal surface and the ceramic basin, protect the ceramic basin, then insert a water inlet pipe and tighten it.

3.The threaded joint into the first water hose, and then the second water inlet hose through the threaded joint.

p201703081736391688651.jpg

4.The second water hose into the inlet port, pay attention to the correct direction, force balance, and then tighten the threaded joints.

5. Put two water hoses into the white plastic pad.

6. Set lock nut to fasten the faucet.

7.Then the sleeve can be tightened.

8.Respectively, lock two into the water pipe and angle valve interface, do not use pipe clamp full plate twist, to prevent deformation or even break. Notice the connection of hot and cold water. Connect the outlet angle valve with the other end of the inlet pipe.


Goodro Kitchen and Bath Co.,Ltd