Goodro Kitchen and Bath Co.,Ltd
Tel:86-18106909390
E-mail:info@goodrofaucets.com
Products
[[TD-Hot Products]]
Exhibition
Home > Exhibition > Content

How to change bathroom sink faucets

Edit: Goodro Kitchen and Bath Co.,Ltd    Date: Jun 12, 2017

Matters needing attention in installing sink faucet

1.The general faucet is shipped with the installation dimension drawing and the use instruction sheet.

2.Before the installation and use should open the Commodity Packaging inspection certificate, so as not to use three no products. If imported goods should be particularly careful.

In addition, should check whether the hardware fittings are complete, general hardware fittings should be equipped with: fixed bolts and fixed copper pieces and gaskets; a full set of basin-lift water, and two into the pipe. Pull out the faucet up and down the handle feel open and close lightly and slightly with the average soft block advisable. And then to check the electroplating surface, to bright, no bubble freckles and scratches prevail.

3.If the faucet is used in the new building, because the water supply pipe network is a new shop will certainly have sand grains and other impurities, before installation should be long water until water quality can be installed. Install the two inlet pipes at one end of the faucet, the other end of the two hot and cold angle valve or connected to two hot and cold joints.

p201612151325056487817.jpg

Goodro Kitchen and Bath Co.,Ltd