Goodro Kitchen and Bath Co.,Ltd
Tel:86-18106909390
E-mail:info@goodrofaucets.com
Products
[[TD-Hot Products]]
Exhibition
Home > Exhibition > Content

Grohe single hole bathroom sink faucet

Goodro Kitchen and Bath Co.,Ltd | Updated: May 27, 2017

Single hole basin faucet installation

 Single-hole basin faucet installation steps Simple point of view is: connect the water hose and basin faucet inlet port; connect the water hose and the outlet angle valve.

1. After buying the faucet, first check whether the fastening parts contain the following basic parts: one copper pad, two rubber washers, one fastening nut;

2. In turn with rubber washers and full copper gasket will be two water hose sets, the basin is a ceramic basin, rubber washers to ease the contact surface with the ceramic basin contact pressure, to avoid porcelain wear;

3. Insert an inlet pipe into the inlet end of the basin faucet and tighten it;

4. Insert the second inlet hose into the water inlet port of the basin faucet and balance the tightening of the copper joint;

5. With the pad from the bottom of the two water hose into the bottom;

6. Tighten the fastening nut to lock the basin faucet;

7. The two ends of the two inlet hose and the outlet angle valve connection, the connection should pay attention to distinguish between cold and hot water in the other side, if the wrong, the faucet can not be wrong. After connecting the two hose and angle valve lock the interface, avoid tightening is too much force, leading to deformation of the interface.

p201612160847016345767.jpg

Goodro Kitchen and Bath Co.,Ltd